View and Download Cisco 1130AG - Aironet - Wireless Access Point hardware installation manual online. Hardware Installation Guide. 1130AG - Aironet. Cisco AIR-AP1142N-N-K9 Pdf User Manuals. Spectrasonics Omnisphere Team Air Keygen here. View online or download Cisco AIR-AP1142N-N-K9 Hardware Installation Manual.

78-18997-01 1 About this Guide This Guide explains how to install and configure your Cisco Aironet 1140 Series Autonomous Access Point. This guide also provides mounting instructions and limited troubleshooting procedures. 2 Safety Instructions Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points, which is available on your documentation CD and cisco.com.

Warning IMPORTANT SAFETY INSTRUCTIONS This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071 SAVE THESE INSTRUCTIONS Warning Read the installation instructions before you connect the system to its power source. Step Up 2 Full Movie In Hindi Free Download Mp4 on this page. Statement 1004 Warning This product must be connected to a Power-over-Ethernet (PoE) IEEE 802. Buku Metodologi Penelitian Suharsimi Arikunto Pdf Download here. 3af compliant power source or an IEC60950 compliant limited power source.

Statement 353 Warning This equipment must be externally grounded using a customer-supplied ground wire before power is applied. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 366 Warning Installation of the equipment must comply with local and national electrical codes.

Statement 1074 Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than: 20A. Statement 1005 Warning Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use. Statement 245B Warning In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332. Note Use only with listed ITE equipment. 3 Overview This section explains necessary tasks prior to installing the 1140 series access point.